Stone cutting machine maintenance guide（2）

6. Always check the electrical components in the control cabinet, whether the wiring screws are loose, and whether the action is sensitive. If any screw is loose, it should be tightened again immediately. Any small negligence will lead to serious consequences.

7. Whether the center of gravity is correct and stable when cutting the block, there must be 10~40mm left at the bottom of the block.

8. Regularly check whether there is water leakage in the spindle box. If found, the cause should be found out immediately, measures should be taken, and the oil should be changed again.

9. Regularly check whether all electrical appliances are safely grounded.

10. Regularly check whether the clearance of each motion guide rail is appropriate.

11. Maintenance of the motor: The coil of the motor of the stone cutting machine is the most important part of the motor. Check carefully whether the coil is damaged or not, and whether the cable is damaged.

12. Regularly clean up the sediment of the whole machine and sink.